Passive Door Lock Not Working

I ve checked the settings multiple times and even turned off and on the passive door lock feature and it is on but it is not working whenever i leave my vehicle running the doors stay open any thoughts or.

Passive door lock not working.

I have change the handles but this did not fix the problem. The doors will not unlock if they do not sense the programmed matched fob. It may return to normal. You must remove the door pad to access this.

It will operate with a dead battery. The other door lock buttons the remotes and the lock switch in the console all worked fine. The turn signals will flash four times to indicate that passive unlocking is now disabled. The dealer replaced the outer door lock handle had to have it painted before installation.

One is the battery powered section that operates the remote door lock unlock. It was replaced under the cpo warranty. There are multiple short range antennas in your gc including one around the perimeter of the spare tire well for tailgate operation. The lock button is part of the handle assembly and is not available separately.

Through some investigation i have found that there is a second antenna system inside the rear passenger door. The second is a rfid like toll roads use and operates the passive entry and push to start. Got the service keyless system message then the next day all passive entry options were not working. They work fine on the passenger side however on the driver front and rear door they do not work.

I went into a store left the car running and when i came back out the doors were unlocked. The exterior passive lock unlock buttons on the doorhandles of my yukon do not work. Eventually it stopped working altogether.