Fixing a clock that runs too fast can be as easy as turning a screw.
Pendulum wall clock runs slow.
Lengthen the pendulum by turning the screw mechanism to the left 1 2 turn.
Moving a clock to a higher elevation will slow it down as the air is thinner.
A pendulum too high causes the clock to run fast.
If the clock is running slow turn the pendulum nut clockwise to increase the rate.
A clock that runs quickly still works fine.
Locate the adjustable weight or screw mechanism near the pendulum arm.
Clocks with an interior or exterior pendulum have adjustment screws either on the pendulum or through a hole in the top of the clock.
It may take up to two weeks to properly set a clock that runs fast.
Can we see the movement.
The pendulum disk is moved up or down by turning the adjustment nut.
Adjust the pendulum up or down.
If it does not have a little slt that has and s and f on each side then it can not be adjusted go to walmart or a hobby shop and buy a new closck mechanism.
The bob will settle lower making the effective length of the pendulum longer.
The clock will run slower.
If the clock is running fast turn the pendulum nut counterclockwise to decrease the rate.
Too low causes the clock to run slow.
To speed up the clock tighten the nut turn it toward your right.
Adjust the bob at the bottom of the pendulum if the clock is running too fast or slow.
To slow the grandfather clock down move the pendulum disk down by turning the adjustment nut to the left.
To slow down the clock loosen the adjustment nut turn it toward your left.
Changing the speed of time keeping is accomplished by moving the pendulum disk up or down.
Pendulum bob with rate adjustment french time and strike.
You may be able to replace the escape wheel with one that has fewer teeth which will require a longer pendulum.
It just needs a simple adjustment.
Denser air causes the pendulum to move more slowly.
Push the bob up to make the clock run faster and push the bob down to make it slower.
Use the following rules to adjust the pendulum nut.
They are cheap and.